OPERATION MANUAL
Operation
The Outside Corner Roller is used to.embed the outside corner bead into the joint compound.
Four rollers of the Outside Corner tool will embed and smooth the corner bead while forming a sharp corner. For best results start in the middle of the corner bead and, with light pressure, roll towards both ends. Then, again from the middle, work from both ends with firm pressure.
This will force the excess compound from under the corner bead and prepare the tape for wipe down.
For best results use a 4 or 6 knife to wipe down the excess mud left from bedding the corner bead.
Maintenance
Clean thoroughly with brush and water (or water hose).to remove all joint compound from the tool. Then, after the tool is clean, lightly oil with Ames Bazooka® Oil.
The 4 Utility Box is used in conjunction with the Utility Box Xtender® Handle to apply the finish coat over corner bead sides.
Mud Consistency: Should be about the same as compound used in a Flat Box Finisher.
